WACO ZQC-6

©2004-2014 Don C. Warrington. All Rights Reserved. Appearances of certain advertisements on this site do not constitute an endorsement.
Please visit our other sites Positive Infinity, vulcanhammer.net and vulcanhammer.info

Important: Click here for Terms and Conditions of this Website

This website is dedicated to the memory of Dorothy W. Grove, Chet's daughter and my aunt, and Kennon G. Freese, her daughter and my dear cousin, both of whom went to be with the Lord in 2003.

Above: Chet with his Waco ZQC-6, S/N 4436, NC-16227.

The WACO aircraft were manufactured by the Weaver Aircraft Company (later called the Advance Aircraft Company) of Troy, OH. The company produced some of the best-loved aircraft of the era; the cabin biplanes (such as Chet's) were a good combination of performance and comfort, making them suitable for sportman pilots or business people, or in Chet's case both.

Chet took delivery of the plane in May 1936 from Waco Sales of New York in Mineola. Having been one of the founders of the Sportsman Pilot Association, he flew it on many of his SPA cruises. The ZQC-6 was powered with a Jacobs L-5, 285 HP engine.  Both the wing and the tail used a Clark Y airfoil profile. The plane was otherwise equipped as follows:

As was typical, he found it apt to put his thoughts about the WACO to verse:

I'll ride you high,
And I'll ride you low,
I'll ride you anywhere
You try to go.
I'll stick to my seat
When the air is rough;
For I promise you, Waco
I've got the stuff.

You can slip and skid
To your hearts content;
But I'll hold you tight
Though you go hell-bent.
You can spin and stall
But I'll call your bluff,
For I promise you Waco
I've got the stuff.

Oh, I'll ride you high
And I'll ride you low
Through fog or snow
Though the path may go.
I'll sit you down tight
When the air is rough
For I promise you Waco
I've got the stuff.

It is interesting to note that, although Chet knew he "had the stuff" for the Waco, the Waco needed some help to keep up with Chet. Some of his needed repairs were as follows:
  • June 1936: new left lower wing, new left upper wing with flap and aileron, left elevator, rudder, tail wheeling locking device assembly and oil cooler assembly.
  • June 1936 again: Upper front strut point fittings
  • November 1936: Reinforced lower front fin fitting, wheel cuffs.
  • November 1937: Heavy duty landing gear centre brace struts

As with all of his planes, Chet eventually cast about for new adventure. In June 1939 he placed the plane for sale at Wings Field in Ambler, PA. His original plan was to replace NC-16227 with another Waco, but he ended up buying a Howard DGA-15 in November 1939.

The Waco itself was finally sold in June 1940. After a couple of owners in Pennsylvania, it went west (literally) to a chopping service in Wyoming. It eventually found its way back to Chet's original "stomping ground" in the Washington area.

Above: NC-16227 in 2003. Unfortunately, as Chet learned more than once, airplanes are prone to land unexpectedly, as the following account reminds us of:

On July 24, 2005, about 1630 eastern daylight time, a WACO AQC-6, was substantially damaged while landing at the St. Mary's Airport, Leonardtown, Maryland. The certificated commercial pilot and passenger were not injured. Visual meteorological conditions prevailed and no flight plan had been filed for the local flight conducted under 14 CFR Part 91.

The airplane was landing on runway 11, a 4,150-foot-long, 75-foot-wide, asphalt runway.

According to the pilot, the approach and touchdown were normal. Shortly after touchdown, the right wing began to rise, and the airplane began to swerve to the left. The pilot attempted to correct with aileron and rudder input; however, the right wing continued to rise, and the left wing struck the runway. The airplane then veered to the right, and nosed over.

Examination of the airplane by a Federal Aviation Administration inspector did not reveal any mechanical malfunctions. Nor did the pilot report any.

The pilot reported 4,246 hours of total flight experience, which included 33 hours in the same make and model as the accident airplane.

Winds reported at airport located about 8 miles east-southeast of the accident site, at 1555, were from 160 degrees at 5 knots. The pilot reported that the wind at the time of the accident was from 200 degrees at 5 knots.

This account, information on the aircraft's history, and the 2003 photo come from Andy Heins, president of the National Waco Club, to whom we are deeply grateful.